Jeffrey Joyce

Return to Community Posts

Forum Replies Created

Viewing 10 posts - 1 through 10 (of 10 total)
  • Author
    Replies
  • in reply to: Window Openings #13855
    JjoyceJeffrey Joyce
    Participant

    Never mind!  I found I needed increase the FRAME DEPTH.  Ooops

     

    in reply to: Artifacts #13844
    JjoyceJeffrey Joyce
    Participant

    I was able to center the vent by deleting the wall segments & creating one wall. Then I used the break tool.  That seem to do the trick.  But the framing artifact remains.  I do have to change the elevate parameters to place the vent.

    Attachments:
    in reply to: Terrain issues #13527
    JjoyceJeffrey Joyce
    Participant

    Thank you!  It seems a lot harder than the old terrain adjustments!

    in reply to: Terrain issues #13517
    JjoyceJeffrey Joyce
    Participant

    With the V15 – c2 upgrade the terrain grade level in the view just continues to rise with no adjustments (see Attached) .  So to clarify, Grade Level does nothing!

    I must adjust building locations to adjust grade level?

    Which parameters?   Floor level of each location?

     

    Attachments:
    in reply to: Terrain issues #13489
    JjoyceJeffrey Joyce
    Participant

    My expectation & previous experience allowed the base level / grade level to act like the elevate command and raise or lower the entire terrain.  there seems to be no effect when adjusting that parameter. The Terrain is displayed 2′ higher than my original design (see yellow arrow).  My expected grade level is similar to Terrain 2.

     

    I still have EV13 & EV14 installed on the computer. When I try to open older version, I get an error message: (See Terrain 3)

    “Unable to access the requested template file.

    The file may be in use or not have sufficient access rights. 0”

    Do I need to remove previous versions of EV?  Maybe reinstall EV15?

     

     

    Attachments:
    in reply to: attic vents #12132
    JjoyceJeffrey Joyce
    Participant

    The wall will not auto extend to the roof, So I created two sloped walls.  Due to it being two walls I cannot located the Louvered vent (round window)  centered in the wall.  Does anyone have any ideas on how to resolve this issue?

    in reply to: Plant Encyclopedia #8895
    JjoyceJeffrey Joyce
    Participant

    Are the Community forums moderated by the staff at Cadsoft?  Are suggestions forward to the decision makers?  Is the Plant Encyclopedia upgradable to include plants not in the library?
     

    in reply to: Terrain in the basement #8896
    JjoyceJeffrey Joyce
    Participant

    It appears that it might be a bug “Auto=cut terrain around building” was selected.  I lowered the Base Level: -6″,  Turn Auto= Off and then On, Restored the Base Level: to 0″.  That seems to have done the trick!

    in reply to: Apron Sink #9648
    JjoyceJeffrey Joyce
    Participant

    Thank you for the Assistance.
     

    in reply to: Realistic is great ! #9651
    JjoyceJeffrey Joyce
    Participant

    How do I insert an Apron Sink in a cabinet?  When I attempt it (after turning off collision), the Counter fills in the interior of the sink.  Please help or enter a “bug” report.
     
    Thank you 

Viewing 10 posts - 1 through 10 (of 10 total)
Return to Community Posts