← Back to Cadsoft Community

Inserting elements across multiple walls

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • March 15, 2020 at 10:38 pm #12242
    jjoyceJeffrey Joyce
    Participant

    I have been trying to figure a way to center a vent in a peak.  The only way I was able to create the peak was with two wall elements, but the vent cannot bridge the two walls.  Is it possible in the next version a collision overide switch might be added?vent

    March 16, 2020 at 9:24 pm #12245
    FynrDzynrFynrDzynr
    Participant

    G’day Jeffrey!

    It’s always preferable to auto extend wall tops to fill in a gable end. Your vent will then insert easily.

    If there’s a mezzanine floor inside it can be a bit more complicated . . .

    hth

    Merv

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)

You have to log in or sign up in order to use our community forum.

Login Register