← Back to Cadsoft Community

Floor Joist Layout off in FT-IN model

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • #16573

    I setup a structural floor joist layout to 16″ on center over 44′. However the last joist member is 1/2″ off from expected. Is that due to conversion tolerance from the Envisioneer metric program to English units Ft-Ins?

    Tom, Building Essentials.


    Hi Tom, is your structural floor like this with the layout starting with one joist and ending with three?


Viewing 2 posts - 1 through 2 (of 2 total)

You have to log in or sign up in order to use our community forum.