← Back to Cadsoft Community

exporting dwg question

Viewing 4 posts - 16 through 19 (of 19 total)
1 2
  • Author
    Posts
  • 2020-10-27 at 10:18 #13202
    conweconwe
    Participant

    Thanks Merv,

    I appreciate it. This pdf printer let’s me duplicate ACAD almost down to a t. I cannot see much of a difference between the two anymore.

    Another good argument with a lot of people is which printer is best: Canon (which is what I have) or HP, which seems to be all my friends use .

    The last while half the time when I try signing into the community to comment it doesn’t let me is this happening to anyone else?: it says signed in and hello but when I go to comment the box doesn’t pop up and I can not reply to(the terrain question for example).

    Conrad

    • This reply was modified 4 years, 6 months ago by conweconwe.
    • This reply was modified 4 years, 6 months ago by conweconwe.
    2020-10-27 at 18:21 #13205
    FynrDzynrFynrDzynr
    Participant

    Gr82hear

    I’ve had an HP LJ800 and LJ8150 for many years but now using a Brother J6920DW AIO (because I can still use generic cartridges in it)

    Yes, every now & then the “community” gets a bee in its bonnet & I’ve not been able to find a solution apart from trying again later.

    avagr8day

    Merv

    2020-10-28 at 17:58 #13206
    FynrDzynrFynrDzynr
    Participant

    I had to login again this morning. When I’d done so it returned me to the page asking me to login or register but once I opened this thread it let me reply OK

    2020-11-05 at 08:09 #13230
    conweconwe
    Participant

    Ha this is a new one for me this morning i went on the community and it said (Hello Conrad) and now i’m logged in and can’t log out (don’t know if it’s good or bad). Guess i will stop trying to figure it out, cause at least i can comment this morning first time in a long time.

  • Author
    Posts
Viewing 4 posts - 16 through 19 (of 19 total)
1 2

You have to log in or sign up in order to use our community forum.

Login Register