Oh…looking at the picture I could see modeling it in envisioneer….a LOT of false cabinet facing using walls with cabinet materials painted on…arch. columns reduced in size…countertop command instead of cabinet counters. Theres a curly ‘brace’ in the catalog for the toe kicks accents
probably use a floor for the tub deck…the rimless sink could be interesting to figure out. I’d probably bypass it. That beveled countertop edge would be impossible I think.
To get crown molding atop your wall cabs I have a wall type I use for cabinet soffits…then add whatever trim you want as crown/baseboard…I’ll usually do this on a separate level to keep things from getting troublesome
It could be done to a fairly close representation I think…just going to take an ungodly amount of work is all
That’s exactly what I’m doing. Except I’m just not sure how much detail I’m gonna put into it yet. The countertop command did not work so i used OSB The Beveled edge i agree is impossible for me. The tub deck I also used OSB For it. But i used cabinets for the bottom cabinets made it a spacer> got cabinet doors from sketchup and then put them against outside and it actually doesn’t look to bad.
Not sure i ever saw the curly brace where in the catalog are you talking about??