← Back to Cadsoft Community

Change to auto exterior dimensions

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #12257
    conweconwe
    Participant

    I was wondering if  it’s possible that you could make it that the auto exterior dimensions go to exterior sheeting instead of the studs or the exterior surface. This is something the people I do prints for want.  And I was wondering if this could be considered in the future updates.

    Thank-You,

    Conrad

    #12259
    louisacolouisaco
    Moderator

    Hi Conrad,

    You can change the settings by going to:

    settings>document settings> dimensions auto exterior>end condition>check box for “core exterior”

    -LC

     

    #12261
    conweconwe
    Participant

    Ok  I just thought it looks like that settings goes to the outside of the stud and not to the outside of the 3/4″ OSB sheeting.

    Thanks conrad

Viewing 3 posts - 1 through 3 (of 3 total)

You have to log in or sign up in order to use our community forum.