Walls in second floor won’t attach correctly. Elevated wall to automeet roof… but look at abnormalities in the images added to this post. You’ll understand my problem better that way.
Wall won’t connect
Trim stays on
problem with appearance on opposite side
Don’t know how to deal with this problem.
Other side…has trim,,, wall markings on the floor
this is how it looks in 2D
It would help if we could see the entire project, in 2D & 3D.
Why elevate walls if this is a 2 storey building? Is there a flat ceilng to part of the 2nd floor but raked ceiling elsewhere?
If you’ve elevated a wall 7′ – 8′ that lines up with another, Env is smart enough to know that they won’t be framed in 1 panel, so it will be displayed as 2 separate wall sections
avagr8day
Merv
this is the 3d view. hope it helps
3d view of project
2d view if it helps
Don’t elevate the wall, just cut an opening in it, centred but about 1/8″ narrower.
You probably don’t want to have Display gable enabled on that end of the roof either
thanks for the recommendation. But the other side of the wall will still have siding……because it needs to go all the way to the roof…that is the problem!
i guess what u say about eliminting the gable…but what if plans require it
thanks for your help
Hi Scel54, I drew what you showed and tried with a hole instead of elevating the wall and a much better inside was the result. The skirting stops before the corner for the wall you cannot see.
The gable is still there, you just cannot see it from inside.
If you give it a go you should see an improvement inside.
Mal.
thanks Mal
Great …will do this…I appreciate it!