45 degree angled cabinets
- AuthorPosts
- December 1, 2020 at 4:38 pm #13337
SDSParticipantI need to model 45* corner cabinets like in the attached plan view pic.
Is this not possible with a cabinet module?
I’m thinking that drawing walls in and laying countertop is the only way…don’t really feel like modeling a toekick with walls though…supposed to be a drop-in cooktop too so I’d prefer to retain the cabinet look here…don’t think walls will allow that
*scratches head*
December 3, 2020 at 10:11 am #13342SDSParticipantWell as the saying goes “fake it till you make it”
It turned out ok…I set the L/R cabinets as normal and measured the angled space between then set an angled cabinet to that width + 1″ to hide the voids. The void is still visible at the toekick but that can be covered easily. Turned cab countertops off and placed a separate counter over the whole assembly
If it were just angled cabs instead of a cooktop I suppose I would’ve used multiple angled cabs instead of just one wide cab, for appearance’ sake.
- AuthorPosts