Pages: [1]   Go Down
« previous next »
Print
Author Topic: Floor slab edge thickness  (Read 208 times)
Allan Chesney
Forum Friend
*
Posts: 682


WWW
« on: July 25, 2012, 09:19:56 PM »
Is there a simple way to show a floor slab tapering to thicker on the edges as in this closeup drawing?

If not, as I suspect, is there a better way than adding a custom Member underneath the slab and deleting the extra lines?

Allan
« Last Edit: July 25, 2012, 09:37:21 PM by Allan Chesney » Logged
Allan Chesney,
Kalamunda, Perth, Western Australia

Envisioneer CS 8 (0.C1.1068)
TurboFloorPlan V16
TurboCAD V17 Professional
FynrDzynr
Global Moderator
Forum Mentor
*****
Posts: 3913


Age=overthehill but I'm not saying which one!


WWW
« Reply #1 on: July 25, 2012, 10:32:55 PM »
G'day Allan!
Strip Footings by picking points then move each segment half the overall width of the beam so the edge aligns correctly.
De-elevate as required.
Sections need a little cleanup but quantities are exact.
Merv
Logged
Envisioneer CS 8.2
Designer-artist-story teller - translating someone's dream (mine or my client's) into words & pictures of what could be
Member, Building Designers Assoc Qld
Member, Australian Architecture Assoc
Allan Chesney
Forum Friend
*
Posts: 682


WWW
« Reply #2 on: July 26, 2012, 04:35:42 AM »
Thanks Merv,

That sounds a better option.

I assume it will accept 2 footings if one is by picking points.

Allan
Logged
Allan Chesney,
Kalamunda, Perth, Western Australia

Envisioneer CS 8 (0.C1.1068)
TurboFloorPlan V16
TurboCAD V17 Professional
Pages: [1]   Go Up
Print
« previous next »
Jump to: