Pages: [1]   Go Down
« previous next »
Print
Author Topic: Cannot turn off hatch pattern on floor  (Read 235 times)
Allan Chesney
Forum Friend
*
Posts: 682


WWW
« on: May 19, 2012, 08:44:45 PM »
I have a section of concrete floor in a model and even though I have set all the pattern surfaces to None, it still displays the pattern.  I need other patterns turned on but not this one. I know I can delete it in the worksheet, but then when I update that, it would reappear.

I must be missing something somewhere - How do I turn it off just on this floor?

Allan
Logged
Allan Chesney,
Kalamunda, Perth, Western Australia

Envisioneer CS 8 (0.C1.1068)
TurboFloorPlan V16
TurboCAD V17 Professional
FynrDzynr
Global Moderator
Forum Mentor
*****
Posts: 3913


Age=overthehill but I'm not saying which one!


WWW
« Reply #1 on: May 20, 2012, 05:19:43 AM »
G'day Allan!
Just set the pattern to "None"
Merv
Logged
Envisioneer CS 8.2
Designer-artist-story teller - translating someone's dream (mine or my client's) into words & pictures of what could be
Member, Building Designers Assoc Qld
Member, Australian Architecture Assoc
Allan Chesney
Forum Friend
*
Posts: 682


WWW
« Reply #2 on: May 20, 2012, 08:55:03 AM »
Hi Merv,

That is what I did, for every surface, 2D and 3D, and it makes no difference.

EDIT:  I looked at it again (for the umpteenth time!) and I had set all surfaces to None EXCEPT the 2D Surface!!  Roll Eyes   Sorry for wasting your time!! (and a whole lot of mine!!)

Allan
« Last Edit: May 20, 2012, 08:58:27 AM by Allan Chesney » Logged
Allan Chesney,
Kalamunda, Perth, Western Australia

Envisioneer CS 8 (0.C1.1068)
TurboFloorPlan V16
TurboCAD V17 Professional
Pages: [1]   Go Up
Print
« previous next »
Jump to: