next »

[Allan Chesney]

When you select an interior wall, the program shows the dimensions to adjoinging walls, but it always shows measurements twice in the same room.  It is usefully obviously if the walls are not parallel and hence the measurements are different and normally having the dimensions twice is not really a problem - unless the room is small and then the dimensions can be on top of each other.

I don't actually recall the dimensions being doubled up in previous version but maybe they were. 

Is there any way of controlling this, so that the dimension only appears once if the walls are parallel?

Allan

[Chantale]

Hi

I will make note and see if our development staff can eliminate that in a future version.

[Allan Chesney]

Thanks Chantale,

It affects TFP also as you would expect.
I could not believe I had not noticed it earlier until I looked back at some old screen images used in a previous tutorial for someone and they were doubled up there too!  I suppose it is only when you are playing around with really small rooms that it stands out - the bulk of time you do not notice it - would be nice to have it fixed though.

Allan